Troubleshooting Guide for Laser Marking Machines

This guide offers practical solutions to common problems encountered with laser marking machines, including how to deal with problems such as the machine not starting up properly, blurry marks, and software glitches.This manual provides a detailed description of the key points of daily maintenance, including cleaning of optical components, cooling system maintenance, and the correct procedures for dealing with sudden power outages. It helps users to quickly troubleshoot problems and extend the life of the equipment.

Rapidly locating common laser marking machine faults.

When the equipment breaks down, don't panic. First check the basics.Loose power cables and dust clogging the cooling fans are often the culprits behind a computer's sudden shutdown.Remember to clean the air intake once a week with a compressed air gun, just like cleaning the dust off a computer.

How to get around the problem of blurred results.

When the image is blurred or double, 80 % of the time this is because the focus has shifted.First try to recalibrate the lens. When operating the microscope, remember to wear a dust-free glove.If the problem persists, check the galvanometer system for moisture, and pay special attention to the galvanometer system during the rainy season if you are in the south.

UDI laser marking special problem handling.

Medical industry users take note: Incomplete UDI barcodes may be caused by software versions that are too old.The company also updates its labeling software regularly, and checks to make sure that no mold release agent remains on the surface of the material.Before marking a stainless steel medical device, wiping the surface with alcohol can greatly improve the clarity of the mark.

What do you do when the software suddenly freezes?

If the program doesn't respond, don't immediately shut down the computer.Press Ctrl-Alt-Del to call up the task manager, then force the program to close, and restart.If this happens frequently, it may be advisable to check whether your computer's specifications are adequate, especially whether your memory needs to be upgraded.

The secret to prolonging the life of equipment.

The laser tube is like the heart of the machine, and I recommend that it be cleaned with alcohol every three months.The cooling system must be changed regularly, and pure water should be used instead of tap water.Before leaving work, I spend two minutes checking the lubrication of the rail, and if I hear an odd noise, I immediately apply the special grease.

Emergency operating procedure after a sudden power outage.

If you experience a power outage, don't turn the computer back on immediately. Let it rest for 10 minutes to discharge the capacitors.After turning it back on, they need to perform an optical alignment test, which is just as important as the calibration test that needs to be performed after a mobile phone has been reset to factory settings.