Three Ways to Extend the Life of a Fixture

Here are three simple tips for keeping your v-blocks in top condition: regular cleaning, lubrication, and proper storage.

Why do curved fixtures require periodic maintenance?

The fixtures are precision instruments, and after long use they tend to accumulate debris or wear down.If left unattended, not only will the clamping precision be affected, but the service life of the entire system will also be shortened.Don't worry. Just follow the three tips below and your clamps will last for years.

Secret 1: Don't be lazy about daily cleaning.

(1) Clean up the debris.

After each use, clean the surface of the fixture of metal shavings and oil with a soft brush or compressed air.Particular attention should be paid to the areas of the surface that are concave, as these are the places most likely to collect dirt.

The use of chemicals is strictly limited.

Never use strong acids or alkalis to clean them. Instead, choose a neutral cleaner and wipe them gently with a soft cloth.If you encounter a stubborn stain, you can dab a little alcohol on it.

Secret two: Lubrication is as important as taking care of your skin.

Use special lubricants.

Ordinary motor oil is too thick, so try a rust-preventing silicon-based lubricant.After spraying, use a cotton swab to spread the solution evenly, and a thin layer is enough.

Focus on joints.

The moving parts and screw threads should be lubricated at least once a month.The process is like changing the oil in a bicycle chain.

Tip 3: Storage posture is important.

Keep away from moist environments.

A few packets of desiccant in your toolbox are a must, especially in the south during the rainy season.If you see any light rust spots, use fine sandpaper (800 grit or more) to gently rub them away.

Avoid stacking them.

Don't play with them as if they were building blocks. It's best to hang them on a special stand or put them in a storage box with slots.Long-term pressure can cause the surface of the lens to deform.

After reading all these methods, are you feeling that maintenance isn't so hard? Remember, 10 minutes of maintenance might save you thousands of NT dollars in buying new tools.The next time you use it, you might want to check the condition of your "old partner.