Daily Care Checklist for Laser Markers

The daily maintenance of the laser marking machine has a direct impact on the life of the equipment and the results of the marking.The manual provides a thorough maintenance checklist covering daily cleaning, key component inspections, software maintenance, and other practical techniques to help users reduce the incidence of breakdowns and improve work efficiency.

You can't be lazy about daily cleaning.

The biggest problem for laser marking machines is dust and dirt, especially for the optical components.Let's first talk about some basic steps in cleaning.

Clean lenses with care.

The lenses are the critical components, and dust will affect the precision of the marking.Use a professional lens cloth dipped in alcohol, and wipe in circles from the center outward. Never rub with a paper towel.After wiping, check to see if any water marks remain.

Don't let dust accumulate on the surface of the machine.

After turning off the computer, wipe the exterior with a soft cloth, paying special attention to the ventilation openings and the trackball.If there is a lot of dust in the workshop, it is suggested that a dust-proof cover be added to the equipment, but care must be taken to ensure that the ventilation holes are not blocked.

Keep your work area clean and tidy.

The metal shavings and adhesive residue produced by the process must be cleaned up promptly, or they can get into the machine and cause a malfunction.Place a small brush near the equipment and get into the habit of sweeping up as you go.

Check critical components periodically.

Like a car, a laser marking machine needs to be serviced regularly.

Optical path system inspection.

Every month, a piece of white paper is used to test the beam for uniformity. If the beam shows any dark spots or splits, it may be that the lens is out of alignment or has aged.New users should contact the manufacturer for advice on adjustments.

Cooling system maintenance.

Water-cooled users should change the water every quarter. Air-cooled users should remember to clean the dust filters.In summer, be especially careful about the temperature of the water; if it exceeds 25 ° C, check the cooling fans.

Oil the moving parts.

The rails and lead screws are lubricated every two months.First, clean off old oil with a cotton swab. Never use butter instead--it's sticky and will attract dust.

Don't ignore software maintenance.

Many people only care about the hardware, but the software also affects the condition of the equipment.

Backups are important.

Each time they found a satisfactory set of parameters, they would immediately back it up in the computer.I've seen clients lose their parameters after upgrading their systems, and they get so upset they stomp their feet.

Software is updated promptly.

The software upgrade packages that are pushed by software vendors usually also include bug fixes, and it is recommended that you check for updates every six months.But remember: Before updating, you must first back up the existing parameters!

Good habits are the most important.

Finally, here are a few common operations that are easy to screw up:

Preheat the oven.

Just as you would warm up a car in winter, after turning the machine on, let the laser run for five minutes before working, especially in cold northern climates.Directly using lasers at high intensity will shorten the life of the tubes.

If there is any abnormality, the machine stops immediately.

If you smell burning or hear an unusual noise, don't try to tough it out. Turn off the power and check it out.Last week, one customer continued to use the machine after noticing a strange smell, and the motherboard was burned out. The repair cost was enough to buy half a new computer.

Keep a log of the maintenance.

A small notebook hangs by each machine, and after every maintenance session the date and contents of the maintenance are recorded in it.It's not easy to forget, and if a problem arises, it's easy to check what went wrong.

If you follow this checklist, your laser marking machine will have no problems for five or six years.If you encounter a situation that you just can't handle, don't hesitate--contact the professionals and spend the money.