6 Tips to Extend the Life of Your Laser Engraver

These six techniques cover daily cleaning, protecting lenses, and calibrating parameters. They help users extend the life of their equipment and reduce the likelihood of malfunctions.By mastering these skills, you can ensure that your laser marking machine runs efficiently and reliably over the long term.

Don't be lazy about everyday cleaning.

Don't underestimate the damage dirt and debris can do to equipment. The optical lenses and guide rails of laser marking devices are the most likely components to accumulate dust.It is recommended that the exterior of the instrument be cleaned with a compressed air gun after each use, and that the lens be cleaned at least once a week with lens paper and alcohol.Remember: when cleaning, always wear anti-static gloves to prevent fingerprints from being left behind.

The lubrication must keep up.

When the oil is gone, the tracks will make a grating sound when the train is in motion.It is recommended that the tracks be checked every month and coated with a thin layer of lubricant from the equipment's original manufacturer.Don't overdo it, as too much oil will make the surface more easily attract dust.

Don't neglect heat management.

The most common problem in summer is overheating. Before turning on the computer every day, make sure the cooling fan is working properly, and don't put anything over the heat vent.If you get a high-temperature alarm, don't panic and force the machine to work. First switch it off and check the water level and temperature setting of the chiller.If possible, the shop should be fitted with air conditioning to maintain a constant temperature.

Be sure to keep a close eye on the condition of the lenses.

The "eyes" of the laser marking machine are the lenses that focus the laser beam.If the color of the marking becomes lighter or the edges become blurred while operating the machine, there is an 80 % chance that the lens is at fault.They recommend that they be professionally tested every three months, and that the lenses be replaced if any scratches are found that are more than 0.2 mm deep.When you put them away, make sure to seal them up to keep them dry, and don't use a regular paper towel to wipe them!

Parameters must be set scientifically.

Many people, in order to get the job done quickly, will turn the power up to maximum, which is really like "slow suicide.Different materials require different parameters, and the suggested values in the equipment manual are not just for show.When working with a new material, a test sample is made first to find the balance point between achieving the desired effect and not overloading the material.

Professional maintenance is a must.

Just as a car requires regular maintenance, a laser engraver should be given a thorough checkup at least once a year.The company would then disassemble the player to examine the condition of the laser, recalibrate the optical system, and replace any worn-out parts.It was money well spent. The cost of a major overhaul would pay for ten years of maintenance!

Change the consumables early.

Don't wait until the laser tube has completely broken down before replacing it. After 20,000 hours of normal use, you should start to pay attention to its output power.It is recommended that you prepare in advance the consumables you will use most, such as protective lenses and filters, which are easily broken.